DODGE S600 Recalls
Item Affected: STEERING:HYDRAULIC POWER ASSIST:HOSE, PIPING, AND CONNECTIONS
Date Announced: 09/10/1974
Description of Recall:
Conequence:
Action Need To Fix It:
Notes: CHRYSLER CAMPAIGN NO 132T. TRUCK. EQUIPPED WITH 361 OR 413 CID ENGINES ANDPOWER STEERING. POSSIBILITY THAT THE POWER STEERING HOSE WAS IMPROPERLY ROUTEDAND MAY CAUSE THE HOSES TO RUB AGAINST THE FRAME OR FRONT ENGINE SUPPORTBRACKET. IF THIS CONDITION EXISTS THE HOSE MAY BECOME DAMAGED RESULTING INLOSS OF POWER STEERING FLUID WITH RESULTANT LOSS OF POWER STEERING. (CORRECTBY INSPECTING AND RE-ROUTING TO PRECLUDE RUBBING OF POWER STEERING HOSE).
Item Affected: POWER TRAIN:AXLE ASSEMBLY:AXLE SHAFT
Date Announced: 07/16/1974
Description of Recall:
Conequence:
Action Need To Fix It:
Notes: DODGE CAMPAIGN NO 130T. TRUCK AND SCHOOL BUS CHASSIS. REAR AXLES SUPPLIEDWERE ASSEMBLED WITH STEEL SPINDLES PRODUCED FROM SAE 1018 STEEL INSTEAD OF THESPECIFIED SAE 1026 STEEL. THIS CONDITION MAY CAUSE SPINDLES TO EXPERIENCEFATUGUE FAILURE, RESULTING IN THE LOSS OF A REAR WHEEL. (CORRECT BY INSPECTINGAND REPLACING ENTIRE REAR AXLE HOUSING WHERE NECESSARY).
Item Affected: SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:HOSES, LINES/PIPING, AND FITTINGS
Date Announced: 04/24/1973
Description of Recall:
Conequence:
Action Need To Fix It:
Notes: CHRYSLER CAMPAIGN NO 110T. TRUCKS. POSSIBILITY THAT THE FLEXIBLE BRAKE HOSESCONNECTING THE LOWER AND UPPER BRAKE MASTER CYLINDER TUBES MAY HAVE BEENIMPROPERLY CLIPPED AND ROUTED. IF THIS CONDITION EXISTS CONTACT BETWEEN THEBRAKE HOSES AND STEERING COLUMN SHAFT COUPLING MAY BE POSSIBLE, WITH CHAFING OFTHE HOSE RESULTING IN A BRAKE FLUID LEAK AND REDUCTION OF BRAKINGEFFECTIVENESS. (CORRECT BY INSPECTING AND REROUTING FLEXIBLE HOSE AND REPLACEWHERE NECESSARY. "
Item Affected: SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:DRUM
Date Announced: 11/30/-0001
Description of Recall:
Conequence:
Action Need To Fix It:
Notes: POSSIBILITY THAT BRAKE SUPPORT BOLTS HAVE BEEN INADEQUATELY TIGHTENED ALLOWINGMOVEMENT BETWEEN BRAKE SUPPORT AND AXLE HOUSING FLANGE. THIS COULD RESULT INSHEARED AT- TACHING BOLTS CAUSING BRAKE FAILURE. (CORRECT BY INSPECTING ANDREPLAC- ING BOLTS WHEN NECESSARY AND TORQUE PROPERLY.)
Item Affected: STEERING:LINKAGES:ROD:RELAY:CONNECTING
Date Announced: 11/30/-0001
Description of Recall:
Conequence:
Action Need To Fix It:
Notes: POSSIBILITY THAT ORIGINAL POWER STEERING CYLINDER TIE ROD CLAMP MAY NOT PROVIDE SUFFICIENT CLAMPING FORCE TO PREVENT MOVEMENT ON ROD UNDER SOME CONDITIONS. MOVEMENT COULD RESULT IN PARTIAL LOSS OF STEERING CONTROL. (CORRECT BY REPLACING CLAMP ASSEMBLY WHEN NECESSARY.)
Item Affected: STEERING:LINKAGES:TIE ROD ASSEMBLY
Date Announced: 01/26/1971
Description of Recall:
Conequence:
Action Need To Fix It:
Notes: CHRYSLER CAMPAIGN NO 071T. TRUCK EQUIPPED WITH 7,000 LB. FRO NT AXLE ANDPOWER STEERING. POSSIBILITY THAT UNDER SOME CONDI TIONS ORIGINAL POWERSTEERING CYLINDER TIE ROD CLAMP MAY NOT P ROVIDE SUFFICIENT CLAMPING FORCE TOPREVENT MOVEMENT ON ROD, C OULD RESULT IN PARTIAL LOSS OF STEERING CONTROL.(CORRECT BY REPLACING CLAMP ASSEMBLY WHERE NECESSARY. )
Item Affected: STEERING:LINKAGES:ROD:RELAY:CONNECTING
Date Announced: 11/30/-0001
Description of Recall:
Conequence:
Action Need To Fix It:
Notes: POSSIBILITY THAT ORIGINAL POWER STEERING CYLINDER TIE ROD CLAMP MAY NOT PROVIDE SUFFICIENT CLAMPING FORCE TO PREVENT MOVEMENT ON ROD UNDER SOME CONDITIONS. MOVEMENT COULD RESULT IN PARTIAL LOSS OF STEERING CONTROL. (CORRECT BY REPLACING CLAMP ASSEMBLY WHEN NECESSARY.)
Item Affected: WHEELS
Date Announced: 11/30/-0001
Description of Recall:
Conequence:
Action Need To Fix It:
Notes: POSSIBLE INTERFERENCE BETWEEN REAR WHEELS AND THE BRAKE DRUM WHICH COULD CAUSE BRAKE DRUM FAILURE AND RESULTANT REDUCTION IN BRAKING EFFECTIVENESS. (INSPECT ALL WHEELS AND REPLACE WHEELS AND/OR DRUMS AS NECESSARY.)
Item Affected: STEERING:LINKAGES:TIE ROD ASSEMBLY
Date Announced: 01/26/1971
Description of Recall:
Conequence:
Action Need To Fix It:
Notes: CHRYSLER CAMPAIGN NO 071T. TRUCK EQUIPPED WITH 7,000 LB. FRO NT AXLE ANDPOWER STEERING. POSSIBILITY THAT UNDER SOME CONDI TIONS ORIGINAL POWERSTEERING CYLINDER TIE ROD CLAMP MAY NOT P ROVIDE SUFFICIENT CLAMPING FORCE TOPREVENT MOVEMENT ON ROD, C OULD RESULT IN PARTIAL LOSS OF STEERING CONTROL.(CORRECT BY REPLACING CLAMP ASSEMBLY WHERE NECESSARY. )
Item Affected: STEERING:LINKAGES:TIE ROD ASSEMBLY
Date Announced: 01/26/1971
Description of Recall:
Conequence:
Action Need To Fix It:
Notes: CHRYSLER CAMPAIGN NO 071T. TRUCK EQUIPPED WITH 7,000 LB. FRO NT AXLE ANDPOWER STEERING. POSSIBILITY THAT UNDER SOME CONDI TIONS ORIGINAL POWERSTEERING CYLINDER TIE ROD CLAMP MAY NOT P ROVIDE SUFFICIENT CLAMPING FORCE TOPREVENT MOVEMENT ON ROD, C OULD RESULT IN PARTIAL LOSS OF STEERING CONTROL.(CORRECT BY REPLACING CLAMP ASSEMBLY WHERE NECESSARY. )
